Battery installation and charging
Install the battery as shown on page 7. Once you have installed
the battery, the screen indicates the battery status (see table
below). If necessary, place the cordless handset in the telephone
base to charge the battery. For best performance, keep the
cordless handset in charger when not in use. The battery is fully
charged after 11 hours of continuous charging. See the table in
the Technical specifications section on page 30 for battery
operating times.
If the screen shows Place in charger and flashes, you need to
charge the cordless handset without interruption for at least
30 minutes to give the handset enough charge to use the
telephone for a short time. The following table summarized the
battery charge indicators and actions to take.
Battery indicators Battery status Action
The screen is blank or
shows Place in charger
and flashes.
The battery has no or
very little charge. The
handset cannot be used.
Charge without interruption
(at least 30 minutes).
The screen shows
Low battery and
flashes.
Battery has enough
charge to be used for a
short time.
Charge without interruption
(at least 30 minutes).
The screen shows
HANDSET X.
Battery is charged. To keep the battery charged,
place it in the telephone
base or charger when not
in use.
NOTE: If you are on a phone call in low battery mode, you hear four short
beeps every minute.
To Next Page
Loading...
Need help?
General
