26
Answering system settings
Using the telephone base:
Press the MENU softkey on the telephone base in idle
mode to enter the main menu.
Press DIR, CID, /DELETE or
/REC
to highlight
Answering sys, then press the SELECT softkey.
Press DIR, CID, /DELETE or
/REC
to choose
Mailbox 1 or Mailbox 2, then press the SELECT softkey.
Press the SELECT softkey again to select
Announcement.
Press the SELECT softkey again to choose Annc audio.
Press DIR, CID, /DELETE or
/REC
to choose
Annc A or Annc B, then press the RECORD softkey.
The telephone base announces, “Record after the tone.
Press STOP when you are done.” After the tone, speak
towards the microphone of the telephone base.
Press the STOP softkey when you finish recording.
The telephone base plays the recorded announcement
and displays Announcement playback. Press the STOP
softkey to stop the playback.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Recording
announcement...
STOP
ANSWERING SYS
Mailbox 1
Mailbox 2
SELECT
ANNC AUDIO
Annc A
Annc B
RECORD PLAY
ANNOUNCEMENT
Annc audio
Annc mode
SELECT
MAILBOX 1
Announcement
Delete all old
Record memo
SELECT