20
Operate
Operation Steps
Join a call in progress
(Use up to four system
handsets/telephone
base at a time on an
outside call.)
f When a handset is already on a call on line 1 or line
2, press LINE 1/FLASH or LINE 2/FLASH on the
handset, or press /LINE 1 or /LINE 2 on the
telephone base to join.
f To end the call:
Press OFF/CANCEL on the handset, or place the
handset in the telephone base or charger.
- OR -
Press /LINE 1 or /LINE 2 on the telephone
base.
The call continues until all handsets/telephone base
hang up.
Intercom
(Use for conversations
between two
handsets/telephone
base.)
Using a cordless handset:
1. Press INT when the handset is not in use.
2. If you have only one system handset, the telephone
base rings.
- OR -
If you have two or more system handsets, press /
to select the destination device -> SELECT.
Using the telephone base:
1. MENU -> / -> Intercom -> SELECT .
2. If you have only one system handset, the handset
rings.
- OR -
If you have two or more system handsets, press /
to select the destination handset -> SELECT.
To Next Page
Loading...
