EasyManua.ls Logo

AT&T Turbo Hotspot 2 - Insert and Install the Battery; Remove the SIM card

AT&T Turbo Hotspot 2
54 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
Insert and Install the Battery
1.
Remove the battery cover and align the battery contacts with the
terminals in the battery compartment as shown.Push the battery down until it
clicks into place.
2.
Replace the battery cover over the battery compartment and press down
on the four corners of the battery cover until it clicks into place.
3.
Your device comes with a charger. To charge, plug one end of the charger
into an electrical outlet and the other end into the device’s USB Type-C port.
Remove the SIM card
1.
Remove back cover, and take the battery out.
2.
Locate the SIM card slot.
3.
Push down on the plastic clip in front of the SIM card, while sliding the SIM
card out of its slot.

Table of Contents

Related product manuals