Atari Tempest - Installation; Voltage Selection

Tempest
TM
C.
Game
Installation
Figure 2 Installation Requirements
Power
Temperature
Humidity
Space Required
Game
Height
250 watts maximum
0 to
38°C
(32 to
100°
F)
Not over 95% relative
64
x
81
cm
(25
Va
x 32
in.)
176 cm (69V2 in.)
1. Voltage
Selection
The
power supply used in
this
game
operates
on
the line
voltage of almost any country in the world.
The power supply comes
with either one, two or
three
colored voltage selection
plugs.
Before
plugging
in your game,
check your power
supply. If the
supply doesn’t
have voltage
selection
plugs and
a connector
at J3 (see Figure
3),
then
the
game operates
on any voltage from
105
to
135
VAC.
If
the supply
has the
colored voltage
selection
plugs, make
sure that
the voltage
selection plug
on
the power supply is
correct for
your location’s
line
voltage.
Check the wire
color on
the plug and
see
if
it is correct
per Figure 3.
2.
interlock
and
Power
On/Off
Switches
To minimize
the hazard
of electrical
shock
while
working
on the inside
of the game cabinet, an
inter-
lock switch
has been installed
(see Figure
4).
It
is
lo-
cated behind the
access
panel.
This switch
removes
all AC line power from
the game circuitry
when
the
panel
is
opened.