Atari Tempest - Page 15

Tempest
TM
Self-Test
Procedure
Part
1
The
information
below
is
displayed
on the
screen
if
you set
the
self-test
switch
to
on
during the
attract mode.
Look
at
the
displayed
numbers
for
SECONDS
ON and
SECONDS
PLA YED.
If
these
numbers
run
together
vertically,
make adjustments to
the
X and
Y outputs
of
the game
PCB.
To
go
to Self-test
Part
2,
rotate the
control knob until the mes-
sage
PRESS FIRE AND SUPERZAPPER
FOR SELF-TEST
ap-
pears
on the monitor. Then press both
FIRE
and
SUPERZAP-
PER. To end the
operator information display, set
self-test
switch to off.
COIN
MECH
MULTIPLIER
SWITCH
AT
N13
(Coin Modes)
SWITCH
TOGGLE 1
SWITCH
AT
(Game
Play)
LIVES
PER GAME
NO. OF
CREDITS
TIME GAME ON
(Seconds)
TIME
GAME
PLAYED
(Seconds)
NO. OF
1-
PLAYER GAMES
NO.
OF
2-
PLAYER GAMES
AVERAGE
GAME TIME
BONUS
ADDER
SWITCH
TOGGLE
8
SWITCH
AT
D/E2
(Game
Difficulty)
GAME
DIFFICULTY
COIN
MODE
LANGUAGE
(English)
Operator
Information
Display
To erase
High Score Table:
1.
Turn control
knob until
top
line reads PRESS
FIRE AND
START 2 TO
ZERO HIGH
SCORES.
2.
Press both
FIRE and START
2.
3.
The word
ERASING appears
and blinks on the
screen until
the
entire table is
erased. Wait
until the word
ERASING
disappears
before
continuing with other tests.
To erase Game
Times:
1. Turn control knob
until
top
line reads
PRESS
FIRE
AND
START 1
TO
ZERO
TIMES.
2. Press both FIRE and
START 1.
3. The word ERASING appears and blinks on the
screen until
the entire table is
erased. Wait until the word ERASING
disappears
before continuing with other tests.
[Self-test Is
continued
on next page]