ATB WATER GmbH, Südstraße 2, D-32457 Porta Westfalica, www.atbwater.com
Service mode
The access to the Service Mode takes place via a 6 figure code number, which is made
available exclusively to the authorised specialist firm.
In the Service Mode all parameters relevant and necessary for the operation of the
wastewater treatment plant are set and changed. Please note that false inputs can lead
to a faulty process!
The inputs are not checked for plausibility! ATB Umwelttechnologien
GmbH rejects any claims under warranty for the results of
inappropriate inputs!
Our service department will be very happy to provide you with support.
Operating parameters
With the selection of the PT number with commissioning,
the parameters lodged in the memory are loaded. At this
point you have the chance of carrying out modifications.
For description of the individual points see above
(Settings).
Product type
Selection of the product type.
Inhabitants
Selection of the connected inhabitants. The associated
parameter values are loaded automatically.
Current Limits
Minimum/maximum current consumption of the individual
units below/above which an alarm signal takes place.
Serial number
Possibility of correction of the serial number, which is
located on the AQUAmax
®
-frame (not the serial number
of the control unit!).
Please ensure that the serial number is entered right-
aligned, in order that leading zeros result.
Floating contact
Activation/deactivation of the floating contact (Standard:
deactivated).
Factory settings
To Next Page
Loading...