QSG_F670_363.00_EN_01_2021-02-09
Allowed longer test time (1s = 100s)
Access to International System or American or Custom
Units
Available outputs for external automatism
CONFIGURATION menu
Use this menu to configure your ATEQ device.
Selection of the language displayed on the screen
Configuration of the pneumatics functions of the device
Configuration of volume calculation for automatic program
selection (option)
Activation of the electronic regulator
Configuration of the electronic regulator (external or auto)
(option)
The electronic regulator is active every time
Configuration of the frequency of the auto zero
Deactivation of the linearization of the regulator during the
auto zero process (option)
Pressure unit by default for the new programs
Configuration of the minimum dump level pressure
Minimum level for checking line pressure (option)
Blowing mode when test cycle is not running (option)
Configuration of the external dump (option)
Remove dump time parameter on the selected program
that becomes 0 second
Configuration of the different communications between
the device and its environment
Configuration of the communication type on the RS232
port
Configuration of the connection type on the USB port
Setup of the built-in clock
Configuration of the programmable outputs
Configuration of the programmable inputs
Bar code reader configuration
Parameters access mode (key or password)
Deactivation of the Start
on the instrument front panel.
Programs can only be started from the instrument relay
board.
Configuration of the assigned function to the Smart key
To Next Page
Loading...
