Need help?Do you have a question about the ATEQ D6 Series and is the answer not in the manual?
Guidelines for electrical safety, output handling, air supply, test environment, operator qualifications, and general device safety practices.
Overview of the manual's purpose and introduction to the ATEQ D6/ERD6 device on the CC-Link network.
Explains numerical values, words, long formats, and address value representation used by the ATEQ device.
Details the ATEQ device's CC-Link board, connectors, and the M12 D coded connector pin assignments.
Illustrates cabling configurations for connecting slaves to a master and between two slaves.
Details the five CC-Link configuration modes, their byte sizes, and functionalities for the slave device.
Guides on setting up the MELSEC master board, describing slaves, downloading configuration, and verification.
Provides a diagram of the ATEQ device's functional modules: Configuration, Cycles, and Results.
Details the command execution flow for starting, resetting, and reading results from the ATEQ device.
Details command and exchange data tables for MASTER <-> ATEQ communication.
Explains parameter downloading, listing identifiers, meanings, and values for device configuration.
Describes the structure of FIFO and Last results, including standard and extended data for analysis.
Explains real-time measurements, status bits, and provides examples for pressure and flow values.
Lists the available SLMP commands for parameter SET/GET operations and device control.
Provides a list of SLMP error codes and their definitions for troubleshooting communication issues.
General| Display | Color Touchscreen |
|---|---|
| Communication | Ethernet, USB, RS232 |
| Measurement Range | -14.5 to 500 psi (-1 to 34.5 bar) |
| Output | Analog, Digital |
| Power Supply | 100-240 VAC, 50/60 Hz |
| Storage Temperature | -20° to 60°C (-4° to 140°F) |
| Test Modes | burst test |
| Humidity | 0 to 90% non-condensing |
To Next Page
