EasyManuals Logo

Athena 2000 Series User Manual

Athena 2000 Series
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
13
Specifications
Supply Voltage: 120/240 Vac, +10% -15%, 50/60 Hz
Setpoints:
Series 2000
: Analog - single-turn
potentiometer, 270° rotation
Series 3020
: Mechanical digital
potentiometer
Setpoint Repeatability: +/-0.3% of span (Series 2000)
Setpoint Resolution:
Series 2000
: 0.2% of span
Series 3020
: 1 °F or °C
Input: Thermocouple Types J, K, T, R (Series 2000)Types J, K
(Series 3020), range dependent.
Maximum lead resistance 100 ohms for rated accuracy;
cold junction compensation standard. RTD input 100 ohms
platinum at 0°C, DIN (.00385) curve.
Thermocouple
Break Protection: Built-in, failsafe, open sensor, output zero;
Meter units – upscale indication
Cold Junction
Compensation: Automatic electrical
Accuracy: +0.5% of span at calibration points
Indication,
Temperature: Deviation meter
+
50 °F (
+
30 °C) of setpoint
Load: LED on when power is supplied to load
Proportional Band: On/off or nominal 5 °F - 50 °F (3 °C - 30 °C)
Offset (Manual Reset): Adjustable over 100% of proportional band
Rate (Derivative): 0.5 to 25 seconds
Reset (Integral): 0.7, 1, 2 or 4 minutes via internal
DIP switches
Alarm: 3 A at 120 Vac
Output: B - SPDT Relay, non-inductive rated
7A/5A max at 120/240 Vac, 50 VA inductive
F - 4 to 20 mAdc into 1000 ohms max load
L - SPDT Relay, non-inductive rated
7A/5A max at 120/240 Vac, 50 VA inductive
S - 20 Vdc into 1000 ohm maximum load
T - 1 A solid-state relay; 10 A max. inrush
Ambient Temp Range: 30° to 130 °F (0 to 55° C)
Weight: 1 lb, 9 oz (709 g)
All specifications subject to change.

Other manuals for Athena 2000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Athena 2000 Series and is the answer not in the manual?

Athena 2000 Series Specifications

General IconGeneral
Input TypesThermocouple, RTD
Output TypesRelay
Control ModesPID, On/Off
AlarmsDeviation
DisplayLED
Power Supply100-240 VAC
CommunicationRS-485