A228/A248/A228I/A248I User’s manual
25
GETTING STARTED
SYSTEM SET UP
The following is a summary of the steps in setting up the system for use.
(1). You can fix the system to a mounting fixture using VESA holes on the back of
the system, always use the screws that come with the unit.
(2). Make any required external connections such as USB, second display,
keyboard, and LAN.
(3). Plug the appropriate end of the power cord into the power connector on
the rear of the system and the plug to an electrical outlet.
(4). Waiting for 3 seconds then press the power switch on the front of
the system once to turn on the system power.
(5). If necessary, run the BIOS SETUP programs by pressing F2 to configure the
system.
Caution:
In order to boot up system from USB-stick or USB-
CD/DVD drive, please connect USB device, turn on
computer power, keep on pressing “F11” key, go into
BIOS quick boot menu, select the USB device, then
press enter, system OS will boot up from USB device
directly.