Atheros AR5B95 - Compliance

Atheros Communications, Inc. • 29
COMPANY CONFIDENTIAL Dec 2008
2. For each simultaneous transmission configuration identified in 6.1, if the
conditions in a) or b) below are satisfied and fully documented in the SAR report
or Class I permissive change documentation, simultaneous transmission SAR
evaluation is not required for that configuration
a) when the [(Σ of the highest measured 1-g SAR for each portable
transmitter/antenna included in the simultaneous transmission configuration ) / 1.6
W/kg] + Σ of [(the highest MPE for each mobile transmitter/antenna included in
the simultaneous transmission configuration) / (the corresponding MPE limit)] <
1; or
b) for antennas included in the simultaneous transmission configuration that
require SAR evaluation, when the separation distance between each antenna pair
is
i) greater than 5 · [(SAR1 + SAR2) / 1.6]
1.5
cm, rounded to the nearest cm, and
ii) the Σ of [(the highest MPE for each mobile transmitter/antenna included in
the simultaneous transmission configuration) / (the corresponding MPE limit)]
< 1
where: Σ in a) excludes antennas that do not require SAR evaluation, and
MPE does not apply to displays < 10” diagonal for both a) and b)
3. If simultaneous transmission condition does not meet requirements described above,
please contact the grantee who is responsible for product compliance to determine the
applicable simultaneous transmission SAR evaluation procedures and applicable
equipment authorization procedure.
7. AR5B95 must be installed and used in strict accordance with the manufacturer’s instructions
as described in the user documentation that comes with the product. The following regulatory
compliance information and information to the user must be included in the user manual of final
system.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy. If not installed and used in accordance with the instructions, it
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by tuning the equipment
off and on, the user is encouraged to try and correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna
-Increase the distance between the equipment and the receiver.
-Connect the equipment to outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Caution: Exposure to Radio Frequency Radiation.