5. Refrigeration connection
Precautions: :
The refrigeration lines must be thermally insulated
scalding and ensure optimal performance.
•
performance and service life of the system. The tubes must be free from bends.
• The 2 tubes that make up the refrigeration line must be separately insulated.
•
• The installation must be correctly vacuum sealed to ensure correct operation and
guarantee the reliability of the system over time.
•
•
•
•
• Plugged
• Pressure resistance: minimum 50 bar
• Minimum tube thickness 0.8 mm
• Maximum tube thickness 1.0 mm
This type of refrigeration lines are available as accessories.
5.1. Shaping
•
to prevent any risk of crushing or breakage.
•
• Do not bend the copper to an angle of more than 90°.
• Do not bend the line more than three times at the same point (risk of incipient break
age and strain hardening of the metal).
• Release the lines from their insulation so that you can properly bend them using the
using adhesive tape.
Warnings Installation Use
5959
EN
To Next Page
Loading...
