Labels
CC 1700 U and CC 1700 S
A. Danger zone
B. Tightening torque
Danger zone
No persons should be within the
danger zone. Fragments of material
which come loose while operating
the hydraulic attachment may be
flung away and can cause serious
injury if people are hit by them.
Small objects falling from a great
height can also cause serious
damage.
Tightening torque
The label states the tightening
torque depending on the screw
size.
ACHTUNG!
Bei Ersteinsatz neuer Zangenmesser:
Nachziehen der Schrauben nach 4h, später
nach je 40h Betriebszeit!
ATTENTION!
When using cutter blades for the rst time:
Retighten screws after 4 hours, thereafter every
40 operating hours!
Drehmoment
Tight. Torque
SW /
Hex. size
10 mm = 105 +10
12 mm = 170 +15
17 mm = 530 +30
Nm
Applications
U version (universal)
Type of applicationField
Light to medium-duty building
demolition, heavy-duty industrial
demolition (heavily reinforced
concrete)
Demolition work
Cutting profiled steel (general
construction steels)
Subsequent reduction
Material separation
S version (steel cutting)
Type of applicationField
Demolition of steel construction
buildings (general construction
steels)
Demolition work
Subsequent reduction
Material separation
Guarantee
The guarantee or product liability will be invalidated
by the following:
● Use other than intended
● Maintenance work not being carried out or being
carried out incorrectly
● The use of incorrect consumables
● The use of non-approved parts
● Damage due to wear
● Damage due to improper storage
● Changes not carried out by or in consultation with
the manufacturer
17© 2015 Construction Tools GmbH | No. 3390 5141 01 | 2015-11-16
Original instructions
OVERVIEWCC 1700 U, 1700 S
To Next Page
Loading...
