Atlas Copco CC 1700 U - Page 24

WARNING Injury by impacts
A sudden movement of the carrier may cause your
assistant to be hit and injured by the boom or the
hydraulic attachment.
► Only move the boom very slowly and in a
controlled manner while an assistant is within the
danger zone.
► Always keep sight of your assistant.
WARNING Hands and fingers being cut off
or hurt
Bores and surfaces can act like a pair of scissors
and cut off or hurt parts of your body.
► Never use your fingers to check bores or fitting
surfaces.
♦
Let your assistant instruct you until the bores in
the adapter plate (B) and in the stick (A) are
properly aligned.
♦
Install the stick bolt (C) and lock it.
A
BC
D
♦
Lift the hydraulic attachment (D).
A
E
FB
G
♦
Extend the bucket cylinder (E) until the bore in the
linkage (F) aligns with the bore in the adapter
plate (B).
♦
Install the linkage bolt (G) and lock it.
♦
Carefully move the bucket cylinder (E) into both
end positions.
The adapter plate must not be stopped by the
mechanical stops in either position. Consult the Atlas
Copco Customer Center/Dealer in your area if the
adapter plate is stopped by a mechanical stop.
© 2015 Construction Tools GmbH | No. 3390 5141 01 | 2015-11-16
Original instructions
24
CC 1700 U, 1700 SINSTALLATION