Atlas Copco CC 1700 U - Page 30

♦
Screw the two Allen screws (L) into the cover.
♦
Unscrew the cover using a rod or pipe.
1.
2.
L
♦
Remove the hexagon head screw (M) located in
the middle of the main bearing pin.
M
♦
Attach the bolt cage (N).
N
♦
Drive the main bearing pin (O) out with a copper
mandrel until it stops at the bolt cage (N).
♦
Fix the main bearing pin (O) with the hexagon
head screw (M) to the bolt cage (N).
2.
M
O
1.
N
The main bearing pin is thus secured against
inadvertantly slipping in.
♦
Move the cutter casing (P) diagonally upwards.
© 2015 Construction Tools GmbH | No. 3390 5141 01 | 2015-11-16
Original instructions
30
CC 1700 U, 1700 SINSTALLATION