Atlas Copco ETP SRB81-1300-20-HA-D - Dual Trigger Safety Precautions; RHMI Interface and Menu Navigation

ETP SRB81-1300-20-HA-D EN Operation
© Atlas Copco Industrial Technique AB - 9839 1649 01
7
■
Press in the reverse switch on the left hand side of the tool, to set the direction counter clockwise
(CCW).
Pistol Grip Models (without side buttons)
■
Double press the function button on the top of the start trigger to shift the direction between clockwise
(CW) and counter clockwise (CCW).
Angle Models
■
Turn the reverse ring to the right, to set the direction clockwise (CW).
■
Turn the reverse ring to the left, to set the direction counter clockwise (CCW).
Soft Start
The soft start function facilitates the screwhead and thread to reach the snug level. The duration of the
soft start is adjustable.
For further information about tightening, see Power Focus 6000 Configuration manual.
Special precaution
WARNING Crushing Hazard
The Dual trigger forces the user to use both hands to operate the tool. If not used, the operator can
accidentally start the tool while adjusting the reaction bar, thus resulting in a serious hand injury.
► Make sure the tool cannot be started once the Dual trigger has been released.
► Always test the tool by first releasing the trigger of the Dual trigger, then push the trigger of the
tool. If the tool starts; stop work.
RHMI
Overview
1 Navigation button
2 Display screen
3 Confirmation button
■
short press to confirm selection
■
long press to go back to previous menu
4 Navigation button