Atlas Copco ETP SRB81-1300-20-HA-D - Assembling Procedures; Component Reassembly Steps

ETP SRB81-1300-20-HA-D EN Service
© Atlas Copco Industrial Technique AB - 9839 1649 01
15
Assembling
Assembling the Accessory Board
1. Attach the cable and insert the accessory board.
2. Tighten the screw on the accessory board
3. Tighten the screw on the lid.
Assembling the Rear Bearing
1. Insert the bearing shield.
2. Tighten the locking screw.
Assembling the Commutation Magnet
1. Insert the commutation magnet.