Atlas Copco ETP SRB81-1300-20-HA-D - Service and Maintenance; ESD Prevention and Maintenance Recommendations; Component Dismantling Procedures

ETP SRB81-1300-20-HA-D EN Service
© Atlas Copco Industrial Technique AB - 9839 1649 01
9
Service
Preventing ESD problems
The components inside the tool and controller are sensitive to electrostatic discharge. To avoid future mal-
function, make sure that service and maintenance is carried out in an ESD approved work environment.
The figure below shows an example of an appropriate service work station.
Maintenance Instructions
Service recommendations
Preventive maintenance is recommended at regular intervals. See the detailed information on preventive
maintenance. If the product is not working properly, take it out of service and inspect it.
If no detailed information about preventive maintenance is included, follow these general guidelines:
■
Clean appropriate parts accurately
■
Replace any defective or worn parts
Dismantling/Assembling Instructions
Dismantling
Dismantling the Front Gear
1. Remove the screw.
2. Turn the locking ring and pull out the front gear.
Dismantling the Dual Trigger
1. Remove the locking screw.
2. Slightly turn the dual trigger to uncover the screw on the front lid.