ETP TBP81-55-10 EN Service
© Atlas Copco Industrial Technique AB - 9839 0853 01
15
Service
General Service Information
If the tool is not working properly, take it out of operation for inspection. Preventive maintenance is recom-
mended at regular intervals. See detailed information on Preventive Maintenance.
■
Make sure to use the service tools, service kits and spare parts recommended by Atlas Copco.
■
Make sure to follow the Service instructions provided by Atlas Copco.
Make sure to work in a clean environment and that all parts are cleaned before re-assembling. For-
eign particles, even small fibers from paper tissue, may affect the service life of the Pulse unit.
Preventing ESD Problems
The components inside the product and controller are sensitive to electrostatic discharge. To avoid future
malfunction, make sure that service and maintenance is carried out in an ESD approved work environ-
ment. The figure below shows an example of an appropriate service work station.
Maintenance Instructions
Service Recommendations
Preventive maintenance is recommended at regular intervals. See the detailed information on preventive
maintenance. If the product is not working properly, take it out of service and inspect it.
If no detailed information about preventive maintenance is included, follow these general guide-
lines:
■
Clean appropriate parts accurately
■
Replace any defective or worn parts
Maintenance
Daily Inspection
■
Make sure that the tool is in good condition, no visual damage.
■
Make sure that sockets and extensions have no visual damage.
■
Listen to make sure that there is no unexpected noise when running the tool.
Preventive Maintenance
There are several criteria that affect the need for service on this tool:
■
Type of joint
■
Torque level
■
Tightening duration
■
Production rate
The service intervals and service solutions are based on experience and internal testing.
To Next Page
Loading...
