Atlas Copco ETP TBP81-55-10

Service EN ETP TBP81-55-10
18
© Atlas Copco Industrial Technique AB - 9839 0853 01
Lubrication Instructions
Lubricating Guide
Brand General purpose
Almagard LE3752
Oil Filling and Changing Instruction for Pulse Unit
Required equipment for oil filling and oil changing:
■
Atlas Copco Pulse unit oil.
■
Atlas Copco Pulse unit Oil Filling Kit.
For ordering number for Spare Parts, see https://servaid.atlascopco.com.
Oil Filling Equipment Kit
■
2 x Adapter M3
■
2 x Adapter M4
■
4 x Hose length 540 mm
■
2 x Hose length 50 mm
■
1 x Hose length 120 mm
■
1 x Syringe 50 ml
■
1 x Syringe 1 ml
■
4 x Plug
■
5 x Connection
■
2 x Connection
■
2 x Can
■
2 x Cover
1. Place the Pulse unit in a vise at an angle so that the outlet whole is at the highest point.
2. Remove the screw covering the inlet opening. Make sure that the o-ring is on the screw and not left
in the Pulse unit. Attach the filling hose by hand, with the hose connector end to the Pulse unit.
3. Fill the large syringe with oil to maximum capacity from the oil can.
Always use new Atlas Copco Pulse unit oil.
4. Remove the stop plug from the filling hose and then attach the syringe to the hose.