Atlas Copco GA 45 VSD - Operating Instructions; Safety Before Initial Start-up

Instruction book



1904 0504 83 ϭϬϯ

 ò  ï  
The operator must apply all applicable Safety precautions.
For the location of the air outlet valve and the drain connections, see
sections
Introduction and Condensate system Important note.

î ï í ò î ò   ë  ð
1. Consult the sections Electrical cable size, Installation proposal and Dimension drawings.
2.
' (
ï  ë ó ó ë )     î ò  ð í ë î    ñ   î ï ð l í ò    ï  î ï  l ì  ð  * ï î ï ì ë  ï  +
• Bolts or bolts and bushes under the oil separator vessel (1)
• Bolts and bushes under the gear casing (2)
• Bolt and bushes or support under the motor (3)

ø ü  ú ÷ õ ø    û   ø ù ú õ         ü         
3. Check that the electrical connections correspond to the applicable codes and that all wires are
clamped tight to their terminals.
The installation must be earthed and protected against short circuits by fuses of the inert type in all
phases. An isolating switch must be installed near the compressor.
4. On air-cooled compressors, check the setting of circuit breaker (Q15). Also check that the switch on
the circuit breaker is in position I.
5. Check the voltage selecting wires at the primary side of transformer T1.