32
LH 11, 18, 19 E, 22, 23 E, 27, 28 E, 39, 40 E
© 2008 Atlas Copco Construction Tools AB
|
No. 3392 5143 01
|
2008-02-29
Overhauling instructions
Mounting of latch in nose
part
1. Grease the lock pin and the spring with
copper grease
2. Mount the lock pin and the spring in the
nose part
3. Place the latch
4. Place the nose part on an anvil
5. Hammer the bigger roll pin with the
opening against the bottom of the nose
part
6. Mount the smaller roll pin with its opening
opposite the bigger one
To Next Page
Loading...
