Atlas Copco PHE 26 RA - Page 10

PAGE
10
Repair Instruction No. 174.3/95
PHE 26 RA
1
7 6
2
3
4
8
9
0,05 mm
2
Illustration A
3 4 5 6 72 1 8
1
9
Assembling the
back gear shaft
1 Push the following parts onto the back
gear shaft (3) in this order:
- washer (4)
- spring (5)
- coupling box (6)
- washer (7)
- tumble drive (2)
2 Press on the gear wheel (1) with a
distance of 0.05 mm to the tumble drive
(2) (illustration A). The smooth surface
must face the tumble drive (2).
3 Insert the locking ring (8).
1 Insert the guide ring (4) and the bolt (3)
into the cylinder (2).
2 Insert the rolls (6) into the back gear shaft
one after the other and fix it with grease.
F
Mount the rolls (6) completely with the
cage (from date of manufacture 06/96).
3 The back gear (7) can only be inserted as
follows:
– Put together the cylinder and the back
gear for adjustment before mounting
them.
– Turn the tumble drive to the lowest
position and leave it there
– insert the cylinder into the end shield
– Insert the tumble drive into the
mounted cylinder.
4 Grease the striker (1) and insert it into the
cylinder.
Mounting the
back gear shaft
and the cylinder