11
PAGE
Repair Instructions No.181.03/98
PHE 6 H / PHE 6 S
Mounting the
crankshaft
1 Insert the O-ring (6) into the gear hous-
ing (C).
2 Press the ball bearing (4) onto the crank-
shaft (5).
3 Insert the crankshaft (5) into the gear
housing from below (C) and fit it to the
connecting rod bearing.
4 Mount the spring ring (3).
5 Insert the key (D) into the crankshaft (5).
6 Fit the crank wheel (2) with the collar fac-
ing the eccentric and press it on.
☞
Steady the crankshaft with a suitable
mandrel which is pushed through the
opening in the cover (otherwise the
crankshaft is pushed in too far).
7 Secure the crank wheel (2) with the spring
ring (1).
8 If necessary, mount the welch plug (7).
9 Fill the gear housing (C) through the serv-
ice opening with grease according to the
lubrication chart.
10Fit the service cover (8) with gasket (B)
and valve (9) and fasten it with the
screws (A).
9
5
6
7
A
8
4
3
D
B
7
2
1
C
To Next Page
Loading...
