13
PAGE
Repair Instructions No.181.03/98
PHE 6 H / PHE 6 S
PHE 6 S:
Assembling the
spindle sleeve
1 Press the buffer (1) into the spindle
sleeve (9) using a mandrel. Mind the
right position!
2 Fit the O-rings (2) to the anvil (3) and in-
sert the anvil into the spindle sleeve (9).
3 Insert the following parts into the spindle
sleeve (9):
- recoil ring (4),
- rubber ring (5),
- retainer (6),
- O-ring (7) and
- spring ring (8).
☞
When mounting the spring ring (8) take
care that it engages in the groove of
the spindle sleeve.
PHE 6 S:
Mounting the
guide sleeve and
the spindle
1 Push the spring (F), the washer (6) and
the bearing (B) as well as the O-ring (7)
over the cylinder (E).
2 Fit the guide sleeve (8) with the O-ring (9)
and fasten it with the secured screws (A).
3
☞
Take care that the spring (F) is located
centrally on the cylinder (E) (see illus-
tration).
4 Push the ball bearing (5) over the spindle
sleeve (G) and secure it with the spring
ring (4).
5 Insert the complete spindle into the hous-
ing.
6 Press the rotary shaft seal (3) into the
nosepiece (2).
7 Fix the machine into a vice provided with
protective chops and fit the nosepiece (2).
Fasten the nosepiece with a torque of
120 Nm.
☞
Attention: The nosepiece (2) has a left-
handed thread!
8 Mount the plastic housing (1).
9 Fit the back part of the housing (D) and
fasten it with the screws (C).
1
9
2
7
6
3
4 5
8
1 2
54
3
68
C
9
G
B
DF
7
A
E
To Next Page
Loading...
