cates that the maximum run timer was violated. The status No
Clutch informs the user that the tool’s clutch did not complete the
fastening process.
The box labeled TOTAL displays the number of batches that have
been completed since the last reset. This number will start at 0
and count up to 65,535 before rolling back over to zero. This
value can be reset through the use of the keypad.
A live pressure indication will appear in the final box labeled
PRESSURE. This pressure value is given in PSI and it represents
the pressure inside the tool’s port.
In the center of the screen, a batch count and the number of fas-
teners in the batch appears. This information is represented as
COUNT of BATCH. The count is the number of fasteners that
have been completed towards the programmed batch setting. The
batch is a number that is programmed into the current parameter.
The batch should represent the number of fasteners in the assem-
bly under construction.
Along the bottom of the screen are several “soft” key indications.
Below each of these soft key indicators is a button. The function
of the button will change as different screens are accessed. The
text in the soft key indicators will also change to inform the user
of the current function of the button below it.
Above the left most soft key on the main screen is an icon that
resembles a padlock. The padlock will be in one of two states,
either open or closed. If the padlock is closed, the unit is locked
and a password will have to be entered in order to access pro-
gramming features. If the padlock is open, programming features
are readily available through the selections on the soft-keys.
RE Qualifier System Manual 4
To Next Page
Loading...
Need help?
General
