Need help?Do you have a question about the Atlas Copco XAHS 950 CD7 T3 APP and is the answer not in the manual?
General| Model | XAHS 950 CD7 T3 APP |
|---|---|
| Emissions | Tier 3 |
| Free Air Delivery | 950 cfm (26.9 m³/min) |
| Working Pressure | 100-175 psi (7-12 bar) |
| Length | 20.6 ft (6.3 m) |
| Width | 7.5 ft (2.3 m) |
| Height | 8.2 ft (2.5 m) |
Key rules for safe operation, maintenance, and general site tidiness.
Guidelines for safely moving, lifting, and setting up the compressor unit.
Precautions for operating the compressor safely, including environmental and noise controls.
Procedures and precautions for safe maintenance and repair tasks.
Detailed safety advice for batteries and pressure vessels.
Details on how the continuous pneumatic system operates and controls output.
Guidelines for safely parking, towing, and lifting the compressor unit.
Instructions for towing and adjusting the towbar levelling device.
Steps to perform before initial start-up, including checks and fluid levels.
Safety precautions related to starting, stopping, and power supply.
Detailed procedure for priming the fuel system and starting the engine.
Step-by-step guide to starting the compressor, including initial displays.
Process of engine warm-up, readiness for load, and loading sequence.
Procedure for stopping the compressor and engine.
Handling shutdown due to alarms and emergency stops.
List of alarm codes, descriptions, fail classes, and triggers.
Details on ECU triggered alarms, including SPN codes and texts.
General safety precautions to be observed during maintenance.
Maintenance intervals based on service hours for compressor components.
Further continuation of maintenance intervals based on service hours.
Notes and additional information for compressor maintenance.
Details on recommended oil specifications for compressor and engine.
Procedure for checking and topping up engine oil level.
Procedure for checking and topping up compressor oil level.
Procedure for changing engine oil and oil filter.
Detailed procedure for changing compressor oil and filters.
Procedures for topping up or replacing the coolant.
Troubleshooting steps for low compressor capacity or pressure.
Troubleshooting for high air receiver pressure and safety valve blow.
Troubleshooting for unit shutdown during operation.
Troubleshooting for air and oil mist from filters after stopping.
Troubleshooting steps for compressor overheating issues.
Troubleshooting for heater not starting, flame extinguishing, or shutting off.
To Next Page