Atlas Copco XAS97 Dd

21
Instruction Manual
4.3 L
UBRICATION OILS
High-quality, mineral, hydraulic or synthesized hydrocarbon oil with
rust and oxidation inhibitors and anti-foam and anti-wear properties
is recommended. The viscosity grade should correspond to the
ambient temperature and ISO 3448, as follows:
Mineral compressor oil PAROIL M:
- 5 liter can: order number 1615 5947 00
- 20 liter can: order number 1615 5948 00
- 208 liter barrel: order number 1615 5949 00
Mineral engine oil PAROIL SAE 15 W 40:
- 5 liter can: order number 1615 5953 00
- 20 liter can: order number 1615 5954 00
- 208 liter barrel: order number 1615 5955 00
Synthetic compressor oil PAROIL S:
- 5 liter can: order number 1615 5950 00
- 19 liter can: order number 1615 5951 00
- 210 liter barrel: order number 1615 5952 00
4.4 O
IL LEVEL CHECK
4.4.1 C
HECK ENGINE OIL LEVEL
Consult also the Engine Operation Manual for the oil specifications,
viscosity recommendations and oil change intervals.
See schedule 4.2.
Check engine oil level according to the instructions in the Engine
Operation Manual and top up with oil if necessary.
4.4.2 C
HECK COMPRESSOR OIL LEVEL
Fig. 4.1 Check compressor oil level
With the unit standing level, check the level of the compressor oil.
The pointer of the oil level gauge (1) must register in the upper
extremity of the green range. Add oil if necessary.
Type of lubricant Compressor** Engine*
between 30°C and 40°C PAROIL S PAR OIL SAE 15W40
between 30°C and -5°C PA ROIL M
PAROIL S
PAR OIL SAE 15W40
between -5°C and -20°C PAROIL S other brand of oil*
SAE 5W40
*
If you want to use another brand of oil, consult the
engine instruction manual.
**
It is strongly recommended to use Atlas Copco branded
lubrication oils for the compressor. If you want to use
another brands of oil, consult Atlas Copco.
Never mix synthetic with mineral oil.
Remark:
When changing from mineral to synthetic oil (or the
other way around), you will need to do an extra rinse:
After doing the complete change procedure to synthetic
oil, run the unit for a few minutes to allow good and
complete circulation of the synthetic oil. Then drain the
synthetic oil again and fill again with new synthetic oil.
To set correct oil levels, proceed as in normal
instruction.
Never mix oils of different brands or types.
Use only non-toxic oils where there is a risk of inhaling
delivered air.
Before removing the oil filler plug (2), ensure that the
pressure is released by opening an air outlet valve (3).
3
1
2