- 39 -
POWER ON / OFF
Switch on the battery switch.
Switch the machine on by switching the “ON/OFF”
switch to the position “ON”. The instrument panel
will now perform a brief selftest.
The display will show:
By pressing the button “F1”, the user goes to the
INFO status.
STARTING
Press the button “I”. During the starting procedure the
display will show:
The system will automatically make 1 attempt to start
the engine. The attempt will be indicated on the
display as: '1/1'.
If the engine failed to start the display will show the
cause of the failure:
When the stopping procedure has ended, the time
message disappears and the F1 function appears
(Reset). The display will show:
Do not disconnect power supply during
operation.
When disconnecting power supply
during operation the user will be
prompted to this by the next display.
To cool down the starting motor, the
system will wait 1 minute before the next
attempt can be made, meanwhile do not
leave the compressor.
To Next Page
Loading...
