Instruction Manual
2954 2510 03 59
4.6 Oil specifications
High-quality, mineral, hydraulic or synthesized hydrocarbon oil with rust and oxidation inhibitors,
anti-foam and anti-wear properties is recommended.
The viscosity grade should correspond to the ambient temperature and ISO 3448, as follows:
4.6.1 Compressor oil
Synthetic compressor oil PAROIL S
Synthetic compressor oil PAROIL S68
It is strongly recommended to use Atlas Copco branded lubrication oils for both
compressor and engine.
Only use synthetic compressor oil.
Type of lubricant Compressor Engine
between -25°C and -10°C PAROIL S
between -10°C and +30°C PAROIL S PAROIL 15W40
between +30°C and +50°C PAROIL S68 PAROIL 15W40
Never mix synthetic with mineral oil.
Remark:
When changing from mineral to synthetic oil (or the other way around), you will
need to do an extra rinse:
After doing the complete change procedure to synthetic oil, run the unit for a
few minutes to allow good and complete circulation of the synthetic oil.
Then drain the synthetic oil again and fill again with new synthetic oil. To set
correct oil levels, proceed as in normal instruction.
Liter US gal Imp gal cu.ft Order number
can 5 1.3 1.1 0.175 1615 5950 01
can 20 5.3 4.4 0.7 1615 5951 01
barrel 210 55.2 46 7.35 1615 5952 01
container 1000 265 220 35 1604 7422 00
Liter US gal Imp gal cu.ft Order number
can 20 5.3 4.4 0.7 1604 7136 00
barrel 210 55.2 46 7.35 1604 7137 00
To Next Page
Loading...
