Important notice:
The Elektronikon controller allows a number of successive commands. Be aware that 2
successive commands need at least 1 minute time lapse to ensure flawless operation.
For example Start Compressor: 5:00 AM, Pressure Setpoint change: 5:01 AM.
Procedure
Starting from the Main screen (see Main screen section),
• Move the cursor to the Menu action button and push the Enter key. Use the Scroll buttons to select
the Timer icon.
• Press the Enter key on the controller. Following screen appears:
(1) Week Timer
(2) Week Action Schemes
(3) Week Cycle
(4) Status
(5) Week 1
(6) Remaining Running Time
The selected item is highlighted in grey. Select the desired item and push the Enter key on the
controller to modify.
Instruction book
2920 1815 04 135
To Next Page
Loading...
