Before using your computer to charge your Atlas,
the USB Drivers should be installed. See Computer
Setup on page 11.
Using the USB cable supplied, connect Atlas to the
computer.
WARNING: DO NOT Remove O-ring from the cable,
this may cause damage and will void your warranty.
The charge is complete when the battery indicator
stops flashing.
Your Atlas may “sleep” after the charge is complete,
if left unattended for 30 minutes or more. In that
case, the screen will go blank. Press any button to
wake it up.
When it wakes up, the battery indicator may at first
read empty. This is normal; the battery is being
tested. The indicator will begin to read properly in
about two seconds.
To Next Page
Loading...
Need help?
General
