Should you have other issues please contact us at
service@atliview.com for further support.
d.Green LED blinks every 1 second (slow
blinking) – The camera has already
connected to the pre-configured local Wi-Fi
network. Please check if the mobile device is
connected to the same local Wi-Fi network.
If it is, please refresh the camera list to see if
the camera is online. Please also check if
the antenna is properly installed and the
camera is not too far away from the router.
If you have any doubt, please move the
camera closer to the Wi-Fi router and then
test again.
Unable to
turn on the
camera
a.The battery may be depleted. Connect the
camera to a 12V-DC power source. Use only
compatible DC power adapter. Please make
sure that the Red LED is ON and then try to
turn on the camera.
b.If the Red LED is not ON, please check the
DC adapter has a rated output of 12V-
DC@2A. If in doubt, please always use the
adapter included.
To Next Page
Loading...