1. Getting Started with Atmel ATmega328PB
1.1. Key Features
• AVR (Harvard) architecture
• Single level pipelining
• In-system reprogrammable flash memory
• Separate EEPROM section available
• Optional boot code section with independent lock bits
• 20MIPS @ 20MHz
• Most single clock cycle execution
• Low power microcontroller with various sleep modes
• High code density (advanced RISC Instruction Set)
• On-chip hardware multiplier
• Short interrupt latency four clock cycles
• Factory calibrated internal RC oscillator
• Security with fuses and lock bits
• Atmel QTouch
®
Library support
• Compatibility between devices (portability)
• Peripheral touch controller
• Clock Failure Detection (CFD)
Note: For detailed information (like AVR architecture, flash size, number of pins, operating voltage range,
number of peripheral channels, module description, etc.) refer to the ATmega328PB datasheet.
1.2. Device Related Website Links
The ATmega328PB product overview webpage (as shown in the figure below) is available at:
http://www.atmel.com/devices/ATMEGA328PB.aspx
Atmel AT08401: Getting Started with Atmel ATmega328PB [APPLICATION NOTE]
Atmel-42482A-Getting-Started-with-ATmega328PB_AT08401_Application Note-08/2015
3
To Next Page
Loading...
Need help?
General
