In the Videos tab the getting started videos (like editor, creating a new C (GCC) project, debugging AVR
applications, debugging ARM
®
applications, etc.) can be found.
http://www.atmel.com/microsite/atmel_studio6/videos.aspx
1.5. Connecting the ATmega328PB Xplained Mini kit
This section helps the user to connect the ATmega328PB Xplained Mini with the Atmel Studio 6.2 SP2
(6.2.1563).
1. Download and install Atmel Studio version 6.2 SP2 (6.2.1563) or later versions.
2. ATmega328PB Part Pack for Atmel Studio 6.2 available in the Atmel Studio link has to be installed.
This bundle adds support for ATmega328PB device in Atmel Studio 6.2.SP2.
Note: There is no need to install part pack for Atmel Studio future versions.
3. Launch the Atmel Studio.
4. Connect the ATmega328PB Xplained Mini to the USB port and it will be visible in the Atmel Studio.
1.5.1. Auto Board Identification of Xplained Mini Kit
• Once the ATmega328PB Xplained Mini kit is connected to the PC, the Windows
®
Task bar will pop-
up a message as shown in Figure 1-4 ATmega328PB Xplained Mini Driver Installation on page
8.
Figure 1-4 ATmega328PB Xplained Mini Driver Installation
• If the driver installation is proper, EDBG will be listed in the Device Manager as shown in Figure
1-5 Successful mEDBG Driver Installation on page 9
Atmel AT08401: Getting Started with Atmel ATmega328PB [APPLICATION NOTE]
Atmel-42482A-Getting-Started-with-ATmega328PB_AT08401_Application Note-08/2015
8