30
CAUTION
DO’S AND DON’TS
Do set up your equipment carefully before each dive and check your entire
system for signs of damage, loose hose fittings, and air leaks. Make sure the
yoke knob or DIN connection is hand tight before turning on your air supply.
Purge the regulator and take a test breath before entering the water.
Do not use your regulator if you notice any problems or malfunctions. Return
it to the factory or authorized dealer to have it checked or repaired.
Do not pick up your tank by the hoses. You may damage them or work loose
a connection that could lead to loss of air.
POST DIVE CARE
A simple fresh water rinse after every dive to clean the regulator of salt, sand or dirt is all
that is required. Do not rinse or soak the regulator in solutions containing bleach
as this can permanently damage the silicone rubber components. Dry or blow
off any water in the first stage dust cap and fit it in place. Rinse through the ambient
ports of the first stage (unless fitted with an anti-freeze kit) and through the mouthpiece
To Next Page
Loading...