23
PARAMETER SETTINGS CONTINUED...
BOOST
BOOST: Turns the BOOST effect on or off. Select ACTIVE to turn it on. Select
BYPASSED to turn it off.
MODE: Select from the following BOOST modes:
OVERDRIVE: Models a classic overdrive pedal similar to the Boss SD-1
SCREAMER: Models a classic overdrive pedal similar to the Ibanez TS-808
DISTORTION: Models a typical distortion pedal similar to a Boss DS-1
FUZZ: Models a fuzz-type distortion pedal similar to a Fuzz-Face
CLEAN BOOST: Models a traditional clean boost drive pedal
INSERT: Select from the following INSERT positions in the signal chain:
BOOST>FX>EQ: Places the BOOST pedal before the modulation effect and pre-eq
effects in the PRE EFFECTS section.
FX>BOOST>EQ: Places the BOOST pedal between the modulation effect and pre-
eq effects in the PRE EFFECTS section.
FX>EQ>BOOST: Places the BOOST pedal after the modulation effect and pre-eq
effects in the PRE EFFECTS section.
DRIVE (0-100%): Adjusts the drive of the boost effect from 0% to 100%.
TONE (0-100%): Adjusts the variable tone of the boost effect from 0% to 100%. Set
low for darker tones and higher for brighter tones.
LEVEL (dB): Adjusts the output level of the boost effect. Can be set to match the
bypassed level or to just provide additional boost or cut.
BUTTON: Assign the BOOST ENABLE functionality to the selected footswitch.
Pressing the assigned footswitch will toggle between ACTIVE and BYPASS mode of
the BOOST. Please note that the assigned footswitch must be in PRESET ASSIGN
mode.
To Next Page
Loading...
