34
PARAMETER SETTINGS CONTINUED...
BASE FREQ (Hz): Selects the starting frequency for the lowest notch filter when it is
at the bottom most location of its sweep.
TYPE (LOG/LINEAR): Adjusts between logarithmic or linear sweeping of the notch
filters. Remember, since our ears work logarithmicly setting this value to LOG will
actually result in us hearing a consistent sweep through the frequencies.
BUTTON: Assign the PHASER ENABLE functionality to the selected footswitch.
Pressing the assigned footswitch will toggle between ACTIVE and BYPASS mode of
the PHASER. Please note that the assigned footswitch must be in PRESET ASSIGN
mode.
TREMOLO
ENABLE: Turns the TREMOLO effect on or off. Select ACTIVE to turn it on. Select
BYPASSED to turn it off.
INSERT: Positions the TREMOLO effect. Choose PRE to position the effect in the
PRE-EFFECTS section (mono, before the amp model). Choose POST to position the
effect in the POST-EFFECTS section (stereo, after the amp model).
LEVEL (dB): Adjusts the level of the output from the TREMOLO effect.
DEPTH (0-100%): Controls the depth of the LFO. As depth is increased, the LFO will
have a wider range. This means that the amplitude modulation effect of the tremolo
will become more and more drastic as depth approaches 100%.
WIDTH (0-100%): Controls the width of the stereo panning effect of the TREMOLO.
When used in conjunction with the PHASE control, panning effects can be created.
For example, to create a panner that oscillates back and forth between the left and
right channels set the WIDTH to 100% and set the PHASE to 180°. The TREMOLO
must be placed in POST position (stereo operation) for this parameter to be
effective.
SPEED (Hz): Controls the SPEED of the LFO which is modulating the amplitude of
the signal.
WAVE (0-100%): Selects the type of LFO waveform used. At 0% the wave will be a
pure sine wave. At 50% it will be a triangle wave. At 100% it will be a square wave. Or
select any intermediate value for interesting blends of these waveforms.
DUTY (0-100%): Selects the duty cycle of the LFO waveform.
PHASE (0-359°): Adjusts the phase offset of the right channel from the left channel
when the TREMOLO is operating in stereo mode. The TREMOLO must be in the
POST position (stereo operation) for this parameter to be effecttive.
To Next Page
Loading...
