35
PARAMETER SETTINGS CONTINUED...
TAPER (0-100%): Controls how the LFO output is used to control the TREMOLO gain.
TAPER controls the mid-point of the overall travel range of the TREMOLO gain. So
at 50%, the TAPER is exactly linear. Below 50%, it is an audio TAPER and above 50% it
is a reverse audio TAPER.
BUTTON: Assign the TREMOLO ENABLE functionality to the selected footswitch.
Pressing the assigned footswitch will toggle between ACTIVE and BYPASS mode of
the TREMOLO. Please note that the assigned footswitch must be in PRESET ASSIGN
mode.
GATE / EXPANDER
The GATE effect features GLOBAL parameter settings. This improves
usability by not forcing users to readjust multiple preset settings every
time the noise levels of the surrounding environment change or if the player
changes to a new instrument.
ENABLE: Turns the noise GATE effect on or off. Select ACTIVE to turn it on. Select
BYPASSED to turn it off.
THRESHOLD (dB): This is a GLOBAL parameter. The THRESHOLD of the GATE
determines is the minimum level of the input signal that will open the GATE. Signals
below the THRESHOLD are reduced in gain by an amount equal to the RATIO (see
below). Set to higher values for a more aggressive gating effect.
RATIO: This is a GLOBAL parameter. Determines how much gain reduction is applied
to signals that are below the THRESHOLD. For example, a RATIO of 2 means that
signals below the THRESHOLD will be reduced by 50%. The GATE is a true dynamic
range expander. Set to higher values for a more aggressive gating effect.
ATTACK (milliseconds): This is a GLOBAL parameter. Adjusts the attack time of the
noise GATE. This controls how much time it takes for the GATE to open once the input
signal has risen above the THRESHOLD.
RELEASE (milliseconds): This is a GLOBAL parameter. Adjusts the release time of the
noise GATE. This controls how much time it takes for the GATE to close after the input
signal has fallen below the THRESHOLD. Set to lower values to allow the GATE to
operate quickly. Be sure not to set too low or you could negatively affect the sustain
and decay of your guitar..
BUTTON: Assign the GATE ENABLE functionality to the selected footswitch. Pressing
the assigned footswitch will toggle between ACTIVE and BYPASS mode of the GATE.
Please note that the assigned footswitch must be in PRESET ASSIGN mode.
To Next Page
Loading...
