8
1.Hold button 3 seconds into setting mode.
2.In setting mode. short press the button to change band.
3.Then hold button 3 seconds into CH setting mode, short press button to change CH.
4.Hold button 3 second to get into Power setting mode, there is short bar on LED, short
press to switch power, 1 bar means 25mW, 2 bar means 200mW, 3 bar means 500mW.
1.⻓按设置按键三秒，进⼊波段设置模式。
2.在设置模式下，短按按键切换波段。
3.再次⻓按按键三秒钟，进⼊频道切换模式，短按按键切换频道。
4.再次⻓按按键三秒钟，进⼊切换功率模式，短按按键切换功率，数码管⼀条为25mw，两条
为200mw, 三条为500mw。
VTX Setting/图传设置
Voltage input/电压输⼊范围: 2~6S Lipo Power/功率: 25/200/500mw Switchable
Power consumption/功耗: 9V 1.1A Frequency/频率:5.3~5.9Ghz
Tx500 VTX User manual/TX500图传说明书
ATOMRC Tx500 VTX Wiring /TX500图传接线图Diagram
GND
VCC/2-6S
5V
Cam Video
To Next Page
