Name: ATOMSTACK A10 Pro
Brand: ATOMSTACK
Rating: 5 (1 reviews)

To Next Page

To Previous Page

2. The computer needs to be connected to the

same Wifi name, otherwise it will cause the

computer to fail to communicate with the engraver.

1. Open the Wifi page and select the WIFI you

would like to connect to. An IP address will appear

in the upper right corner of the screen when it is

connected.

3.Enter the IP address displayed on the touch screen in the

browser address bar, and click OK.

4. Click choose files and select the

configuration file.

The display screen and the computer are connected to the same WIFI, open the

browser and enter the IP address

Other manuals for ATOMSTACK A10 Pro

Questions and Answers:

Need help?

Do you have a question about the ATOMSTACK A10 Pro and is the answer not in the manual?

General

Laser Power	10W
Laser Wavelength	455nm
Connectivity	USB
Engraving Accuracy	0.01mm
Output Voltage	12V
Engraving Area	410mm x 400mm
Material Compatibility	Wood, Plastic, Leather
Control Software	LaserGRBL
Laser Protective Cover	Yes
Input Format	BMP, JPG, PNG, DXF
Power Supply	AC 100-240V, 50/60Hz
Focusing Method	Fixed focus laser, no need to adjust focus before engraving