Name: ATOMSTACK MAKER R1
Brand: ATOMSTACK
Rating: 4 (1 reviews)

To Next Page

To Previous Page

L-shaped jaws

Screw 3*6mm

H2.5 hexagonal

plate hand

Step 2 (A1): Installation of L-shaped jaws (method 2)

5.Installation guide

Note:

1. When engraving a cued suace, take the average value of the diameter/circumference of the actual engraving

range of the measured object (the average value of the left, middle and right of the engraving range position)

2. When tilting and engraving, adjust the appropriate position of engraving by rotating the button

3. Round bottom object engraving

Questions and Answers:

Need help?

Do you have a question about the ATOMSTACK MAKER R1 and is the answer not in the manual?

ATOMSTACK MAKER R1 Specifications

General