Make sure you have placed the chuck module parallel to the working area of the engraving machine before rotating the engraving,
otherwise the pattern engraved on the object may be deformed
T to make the three contact suaces of the object under test and the jaw assembly at
When the sphere needs to be removed after engraving, rst loosen the chuck knob and then loosen the bracket xing knob
Do not forget to update the parameters of the measured object in the rotation setting window eve time you change the
measured object
Turn o "Enable Rota" in the main window when plane engraving, otherwise the engraving pattern will be deformed
If you are using this product for the rst time, please read the accompanying materials carefully to improve your experience. If you do
not use the product in accordance with the instructions and requirements
or due to mishandling of the product, etc., ATOMSTACK shall not be liable for any loss resulting therefrom.
ATOMSTACK has carefully checked the contents of the manuals, but there may still be errors or omissions. ATOMSTACK is committed
to continually improving the functionality of its products and the quality of its seices, and therefore resees the right to change any
manuals and the products or software described in the contents of the manuals without prior notice.
7.Notes
15
1.
2.
3.
4.
5.
6.
7.
To Next Page
Loading...
Need help?
General
