ATON AH66T INSTALLATION MANUAL
© ATON 2010 | All rights reserved. Page 11
ATON pre-wiring recommendations for connections to the AH66T
Item Description
IR Receivers Category 5cable
Category 5cable for control wiring
16-18 AWG 2 or 4 conductor wire for speaker wiring
Use stranded, twisted pair speaker wire between amplifiers and volume controls,
and between volume controls and speakers.
16-18 AWG speaker wire
Use stranded, 2 or 4 conductor speaker wire between amplifiers and speakers.
Remotely Located Sources
Category 5 cable
RG6 or RG59 coax (if necessary)
ELAN C2 Communications
Controller
Category 5 cable When using an ELAN C2 Communications Controller, run Cat-5
for telephones and door stations. See the C2 Installation Manual for details.
Serial Devices
Category 5 or Serial Cable
Run Cat-5 or serial cables between RS-232 controllers and the AH66T.
Sense Inputs
Category 5 (3 conductors used)
Use Cat-5 to extend sensor leads, if necessary.
System Audio RCA Interconnect Cables
To Next Page
Loading...