ATON AH66T INSTALLATION MANUAL
© ATON 2010 | All rights reserved. Page 17
Mono Zoning
Rooms with no definite listening area (kitchens, hallways, L-shaped rooms, for example)
are ideal for mono applications. The AH66T can combine stereo source signals into a
single mono output that is available on two channels. Stereo / Mono selection is done on a
zone by zone basis using the ATON configuration software.
(Factory Default setting is STEREO.)
Note: The amplified outputs and the preamp outputs for any particular zone are linked.
They can either BOTH be stereo or BOTH be mono.
DO NOT bridge the speaker outputs of the AH66T. Each speaker output (Left and Right)
will have both channels of audio information.
Figure 2-4 shows a mono zone application.
To Next Page
Loading...