ATON AH66T INSTALLATION MANUAL
© ATON 2010 | All rights reserved. Page 36
iPort
®
Integration (Continued)
IW-22
In the ATON configuration software determine which Comm Port and Source Audio Input
you will be using to connect to the iPort. Connect all iPort components according to the
IW-22 installation manual. Verify functionality of the IW-22.
Connect a Cat5 (TIA/EIA568A or B) from the selected Comm Port of the AH66T to the
DB9M-RJ45 adapter. Connect the RS-232 Control Cable (included with the IW-22) to the
adapter. If IR control is also required, connect the IR Emitter Output of the AH66T to the IR
input port of the IW-22’s Audio Wall Plate. Connect the audio output of the IW-22 Audio
Wall Plate to the Source Audio Input of the AH66T.
Figure 4-3: IW-22 Connections
iPort feedback is only displayed on the OLED2s. It does not “pass through” to 3
rd
party
controllers.
To Next Page
Loading...