5.11 CHECK EMERGENCY MESSAGE
The message you recorded in previous Chapter can be
verified
• Press PRO
• Press ▲ 5 x to select “CHECK MESSAGE”
• Press to listen to recorded message
• Press PB/D to leave menu
To erase recording, press DL during playback
After all programming is complete, you can switch program
lock ON (22) This can prevent accidental erasure of settings.
5.12 PAIR NEW PENDANT / REMOVE ALL PENDANTS
The pendant is registered in the telephone by its ID Code. In
case of repair or other reason, it can be necessary to register
the pendant to the telephone. The pendant can also be
deleted from the telephone. A total of (5) pendants can be
paired to the system.
To pair a pendant:
• Press PRO
• Press ▼ 3 x to select “PAIR NEW PENDANT”
• Press “PAIRING” will be displayed
• Press to start pairing process
• You will see “Pairing ……”
• Press SOS button on pendant
• “DONE” will appear if pairing is successful
• Press PB/D to leave menu
to remove a pendant:
• Press PRO
• Press ▼ 3 x to select “PAIR NEW PENDANT”
• Press “PAIRING” will be displayed
• Press ▲ or ▼ to select “DELETE?”
• Press to delete all pendants
• Press PB/D to leave menu
Page 16
5.8 STORE TELEPHONE / PHONEBOOK NUMBERS
You can store up to 30 phone numbers / names in the
telephone. As few as 1 or all 30 numbers can be set as
emergency numbers. NOTE: If storing 911 in emergency
contact list, store as the last emergency contact.
• Press PRO
• Press ▲ 2 x to select “STORE NUMBER”
• Press to enter
• Enter telephone number to be stored
NOTE: To store a pause while programming, press RD/P
To store a * or # while programming, press those keys
• Press DL to delete a wrong entered number
• Use ▲ and ▼ to move back and forward through number
• Press to confirm
• Enter name using characters on numeric keypad
• Press DL to delete a wrong entered character
• Use ▲ and ▼ to move back and forward through entered
characters
• Press to confirm
• Select “EMERGENCY OFF” or “EMERGENCY ON”
In case of “EMERGENCY ON” you need to select position of
this number (specifies in what order it will be dialed)
- Use ▲ and ▼ to select position
- Press to confirm
In case you want to overwrite an existing position, you will
have to confirm “OVERWRITE?” by pressing . When
number is saved, menu will automatically go to “NAME
RECORDING”
• Press and hold and wait for a beep
• After the beep, say name of stored contact
• Release button to finish recording
• Press PB/D to leave menu
The maximum length of the recording is ‘3’ seconds
Page 13
To Next Page
Loading...