• Press to enter settings
• Use ▲ and ▼ to change digit
• Press to move to next digit
• Repeat this sequence until all digits are set. Leave un-
used digits as “- “
• Press PB/D to leave menu
5.6 SET DIAL MODE – PULSE OR TONE (DTMF)
The telephone can dial in Tone (DTMF) or Pulse mode. By
default, the telephone is set to Tone (DTMF) mode.
• Press PRO
• Press ▼ 4 x to select “SET DIAL MODE”
• Press to enter settings
• Use ▲ and ▼ to select “PULSE” or “TONE”
• Press to confirm
• Press PB/D to leave menu
5.7 SET FLASH TIME
Flash is used for services like “call waiting” (if service is
provided by telephone company) or to transfer calls when
connected to PBX system.
Depending on the country, flash time can vary. The telephone
supports (3) possibilities: 100, 300, 600 msec
• Press PRO
• Press ▼ 5 x to select “SET FLASH TIME”
• Press to enter settings
• Use ▲ and ▼ to select desired flash time
• Press to confirm
• Press PB/D to leave menu
Page 12
5.13 DAILY ALARMS
The telephone has two daily alarms that can be set. When the
alarm time arrives, the telephone will alarm for up to 30
minutes. If the user presses the panic button on the pendant
or the SOS button on the telephone, the alarm will be
cancelled.
If the user Does Not press the panic button on the pendant or
the SOS button on the base of the telephone it will begin to
call the emergency contacts and play a Custom Daily Alarm
message to let the receiver of the call know the user was
unable to press the panic button or the SOS button on the
telephone.
When both daily alarms are set this will ensure that the user is
OK during the two alarm times each day.
5.13.1 How to Set the Daily Alarm
⚫ Press PRO
⚫ Press 1 x ▼ to select “DAILY ALARM”.
⚫ Press
⚫ Press ▲ or ▼ select “DAILY ALARM 1” or
⚫ “DAILY ALARM 2.”
⚫ Press
⚫ Press ▲ or ▼ select “ALARM OFF” or “ALARM ON”
⚫ Press
⚫ Press ▲ or ▼set for hour.
⚫ Press
⚫ Press ▲ or ▼set for minute
⚫ Press to confirm,
⚫ Press to leave the menu. ---------
Page 17
To Next Page
Loading...