40
the peak power to the cut-off power).
Note: Only the system with optional wireless control module has the power slow
down function!
5) Power start:
Show the power when the light starts.
6) Power off:
Show the power when the light is stopped.
7) WireMoment:
If the control system is equipped with a stepping wire feeder, the torque of the
stepping wire feeder can be adjusted according to the load of the stepping wire feeder.
8) Stop delay:
After setting the light-off delay time, the light will not be turned off immediately after
releasing the off switch of the welding head, but the light will really stop after the light-off
delay period. Use the time of the light-off delay to realize that the welding wire is separated
from the workpiece after the light is stopped.
Note: The light-off delay time is up to 500ms. When the light-off delay time is
set too long, please confirm that the light has been stopped before placing the
welding head to prevent laser damage.
9) Pulse-Time:
Set the light emission time in burst mode, the maximum burst time is 1000ms.
10) Blow switch
Open/close solenoid valve
11) Offset
Adjust the lateral offset of the optical core
12) Back Feed:
After the light is stopped, the welding wire will automatically return to a certain length,
which is convenient for the next welding. The length of the wire back is determined by the
set parameters.
13) Off light wire feeding delay
After the completion of the light off and wire return action, the wire feeder will feed
the wire again after this delay.
To Next Page
Loading...